There are several things to remember when removing and refitting a Chrysler radiator.

The first is the fragility of the unit. Most modern Chrysler radiators are made from an aluminium centre core capped on both ends with plastic tanks.

Unlike the older copper and brass Chrysler radiators they are not easily repaired and even the slightest nick in the aluminium core can render the Chrysler radiator useless.

The Chrysler radiator plastic end tanks are also fairly fragile and great care should be taken to not knock the plastic locating pins.

NEVER remove a Chrysler radiator cap from a Chrysler car radiator expansion tank or Chrysler radiator whilst the engine coolant is still hot. Great pressure can build up in some Chrysler radiator systems and the fitter must be sure that the engine and it's cooling system have had sufficent time to cool.

If your Chrysler replacement radiator is of copper and brass construction be careful  not over tighten any threaded fittings such as the hole for the Chrysler radiator fan switch. The fittings are only soft soldered into the Chrysler radiator tank and can easily be broken if over tightened.

Care should also be taken when removing and refitting the Chrysler radiator hoses on to the Chrysler radiator pipes, again these fiitings are soft soldered and can form leaks if excessive force is used.

If your Chrysler radiator has an inbuilt oil cooler with threaded fittings for the pipes ensure they are not cross threaded when attaching.

Always, always, always replace the anti freeze solution when refilling the Chrysler radiator. The antifreeze also acts as engine coolant as it has a higher boiling temperature than water. Aways use the manufacturers recommended solution and observe the correct ratio of water to anti freeze.

When you are confident that the Chrysler radiator is fitted correctly and all pipes are sufficently tightened you will need to run the engine until it gets warm enough for the thermostat to open and circulate the water through the entire system. It is ESSENTIAL to remove any trapped are from the Chrysler radiator cooling system as air expands greatly and can blow a Chrysler radiator from the pressure build up.

It is advisable to set the heater temperature control to HOT as this will allow water to circulate through the unit. Do not switch the fan on as this will only slow the process of heating the system.

If you are in any doubt about removing or refitting a Chrysler radiator you should leave it to your local garage or Chrysler radiator specialist.

If this guide was of any use to you please give us a positive vote!

You can buy all of your Chrysler radiators and air conditioning parts in our eBay Shop