How to assemble flatpack pull bows:-

Hold the two pull cords with your right hand, which are located in between the ribbon on one end. Drape the same end of the bow either side of your left hand. Pull the pull cords between your thumb and first finger and the bow will form against your left hand. Keep pulling until the top of the bow completely forms the bow. Be careful not to over pull as the pull cords can come unattached. Tie off the bow with the two ends of the pull cords. You can then drag the cords over the edge of a knife or ruler, be careful not to drag over anything too sharp (sharp knife, scissors) as this can damage the cord. Cut to the desired length. If the pull cord does not spring into a curl first time keep dragging over the knife and sooner or later it will spring into a coil. It can take some practice but you can do it as many times as it takes.

1. Open tails to reveal the tie-strings
2. Hold tails open with one hand
3. Pull tie-strings with the other hand to form a bow
4. Knot tie-strings at base of bow and then around package

If you found this guide usefeul please click below. If you didn't please email us and tell us how we could improve it

cheers