Hello everybody.

Firstly, I must apologise to all those who have purchased these instructions from me over the past few months.

From May this year, Ebay revised their Downloadable Media Policy & decided to ban all digitally delivered items. This meant that the instructions that I have been successfully emailing to people were now banned from being delivered by email. I could have elected to print each set out & post them to buyers, but to be perfectly honest this would be both time consuming & an unnecessary use of resources (printer ink, paper, envelopes etc.) so I decided to simply stop listing in order to be a good boy & comply with the policies.

Unfortunately, not all members are as good at sticking to the rules as myself & several are still listing on a nudge, nudge, wink, wink, "I won’t actually state that I email the instructions even though I do" basis. This guide is dedicated to these members.

It would seem that the only way to make sure everybody sticks to the rules is to make sure that the information is made available to all, so rather than paying for the instructions to be emailed, here they are for free:

SYSTEM DESCRIPTION

The Central Door locking is controlled by the Multi-Remote Control system which controls the door locking, door super locking and hazard reminder. When the doors are locked and unlocked the unit flashes the hazard lights once for lock and twice for unlock.

A maximum of 4 remote controls are allowed to be programmed.

ALMERA, ALMERA TINO, PRIMERA, MAXIMA, MICRA, SERENA, VANETTE CARGO, TERRANO II

Ensure all the doors have been unlocked, either by using a good transponder key or remote control plip key. Some models may require the accelerator pedal to be held down through the procedure.

Procedure

1. Turn the ignition switch from Position 0 to ON 6 times within 10 seconds.

2. Then turn ignition switch to OFF position. Leave key in ignition switch.

3. After 2 seconds, the system will enter programming mode and will flash the warning lights twice.

4. Press and HOLD the unlock button on the Plip.

5. While pressing the unlock button, press the lock button 3 times.

6. Release the unlock button.

7. The warning lights will flash once to indicate successful programming.

8. Repeat procedure 4 to 7 for up to 4 plip key’s.

9. When completed turn ignition ON, and the warning lights will flash 2 times.

10. Remove key, and check all plip key’s for operation.

NOTE : The programming mode will stop when either the ignition is switch ON, 4 plip keys have been programmed or no input signal either from the switch or plip keys has been received for 120 seconds.

xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx